Mold-Masters TempMaster M2 Plus Series - Page 8

10.2.3 Set Power Rail to Delta Conguration ...................................................10-4
10.2.4 Delta Supply Wiring ...............................................................................10-5
10.3 Loom Thermocouple Cables ..........................................................................10-5
10.4 Loom Power Cables .......................................................................................10-5
10.5 Alarm Output / Auxiliary Input .........................................................................10-6
10.6 Serial Port .......................................................................................................10-6
10.7 USB Port ......................................................................................................... 10-7
10.8 Filter Option ....................................................................................................10-7
10.9 Touchscreen Schematic .................................................................................10-8
Section 11 - Water Manifolds .........................................11-1
11.1 Introduction .....................................................................................................11-1
11.2 Installation .......................................................................................................11-1
11.3 Monitor Coolant Properties .............................................................................11-2
11.4 Display for Water Flow Zones ......................................................................... 11-2
11.5 Conguration ..................................................................................................11-4
11.6 Detect and Congure Water Flow Zones ........................................................11-4
11.7 Congure Water Flow Zones .........................................................................11-6
11.7.1 Congure Water Flow Parameters - Zone by Zone ...............................11-6
11.7.2 Congure System Settings for Flow Zones ............................................11-7
11.7.3 Congure Tool Settings for Flow Zones .................................................11-9
11.7.4 Link Flow Zones ...................................................................................11-10
11.7.5 Set the Reynolds Number Alarm Parameters ...................................... 11-12
11.8 Flow Control Option ......................................................................................11-14
11.8.1 Congure Flow Zone Output ................................................................11-14
11.9 Set the Flow Rate ........................................................................................11-15
11.10 Turn Flow Zones O󰀨 and On ....................................................................... 11-16
Section 12 - Optional Cards.......................................... 12-1
12.1 16DLI - 16 Channel Digital Logic Input Card ..................................................12-1
12.2 WT3 12 Channel RTD Input Card ..................................................................12-1
12.3 WT4 12 Channel Thermocouple Card ............................................................12-1
12.4 AI8 - Analogue Input Cards ............................................................................. 12-1
12.5 AI04 - 4 Channel Analog Control Card ...........................................................12-1
Section 13 - Quad IO Options ....................................... 13-1
13.1 Quad IO Screen .............................................................................................. 13-1
13.2 Quad IO Card Reset Timer .............................................................................13-4
13.2.1 Set the Quad IO Reset Timer ................................................................13-4
13.3 Quad IO - Inputs .............................................................................................13-5
13.4 Quad IO - Outputs ..........................................................................................13-6
13.5 Quad IO - Default Connections ......................................................................13-7
13.6 Remote Tool Selection ....................................................................................13-8
13.7 Remote Tool Loading ......................................................................................13-8
13.7.1 Static Remote Tool Load ........................................................................13-8
vi
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
M2+ Controller User Manual