Molecular Devices SpectraMax iD3 User Manual

SpectraMax iD3 Multi-Mode Microplate Reader User Guide
30 5054747 B
You can use the SoftMax Pro Software on a connected computer to operate the instrument
and you must use the SoftMax Pro Software to run injector reads. See the SoftMaxPro User
Guide.
Illustration Part Number Description
5052189 CAT6 Ethernet cable, 2meter (6.56foot)
4400-0002 or
4400-0036
Power cord, 1meter (3.3foot)
Table 2-5: Required Accessories
To connect the cables to the instrument:
1. Make sure the instrument is placed on a dry, flat work area with sufficient space for the
instrument and the required cables. To ensure ventilation and provide access to
disconnect the power from the instrument, maintain a 20 cm to 30 cm (7.9 in. to 11.8 in.)
gap between the rear of the instrument and the wall.
2. Connect one end of the supplied Ethernet cable to the Ethernet port on the instrument
and then connect the other end of the Ethernet cable to a network wall outlet.
Figure 2-15: Instrument rear - power port and Ethernet port
3. Use the power cord supplied with the instrument to connect the instrument to a
grounded electrical wall outlet.

Molecular Devices SpectraMax iD3 Specifications

General

Brand	Molecular Devices
Model	SpectraMax iD3
Category	Laboratory Equipment
Language	English