Chapter 3: Home Page
5054747 B 59
3. Twist the snorkel clamp to clear the position where the bottle is to be placed.
4. Remove the old bottle, if present, and then place the new bottle into its position.
5. Move the snorkel clamp back into position over the bottle.
6. Slide the snorkel all the way down into the bottle and then slide the snorkel tube into the
open end of the snorkel clamp.
The bottle holder is slightly tilted toward one corner. To extract the maximum amount of
liquid from the bottle, place the end of the snorkel in the lowest point that is located in
the corner of the bottle closest to the closed end of the snorkel clamp.
Figure 3-13: Lowest points of the bottle holder
7. Follow the previous steps to insert a second bottle into the right side bottle position for
injector 2, if needed.
Injector Maintenance - Status
The Status tab on the Injector Maintenance page display how many milliliters (ml) of liquid
have been dispensed through the tubing. The lifetime of the tubing is limited and you must
replace the tubing when worn.
After you replace the tubing, touch Reset Volume to reset the counters to zero.
Tip: When the injector is not in use and the tube is empty, open the tube stabilizer lid
over the injector pump to extend the tubing lifetime.
To Next Page
Loading...
Need help?
General
