molex Brad HarshIO 600 eIP - Ethernet Link (0 Xf6)

HarshIO 600 eIP
•
61
•
IP67 IO-Link Modules for EtherNet/IP
Ethernet Link (0xF6)
Class Attributes
Id
Description
Get
Set
Limits
1
Revision


4
2
Max Instance


3
3
Number of Instance


3
 Supported  Not supported
Class Services
Id
Service
Param. Options
01h
Get_Attributes_All
0Eh
Get_Attribute_Single
Instance Attributes
Id
Description
Get
Set
Values
Instance 1
(ETH 1)
Instance 2
(ETH 2)
Instance 3
Internal Port
01
Interface Speed


Current Speed
100
02
Interface Flags


Link Status: shall be set is a link is present on module
Half/Full Duplex: shall reflect the duplex of the port
Negotiation Status:
- If no Link : Auto-negotiation not attempted
(in this case Link Status and Half/Full
Duplex forced to “not set”)
- If Link and attr6 not in Auto-negotiate: Auto-
negotiation not attempted
- Other case: Current auto-negotiation result
- Link Status set
- Half/Full Duplex set
- Auto-negotiation no
attempted set
03
Physical Address


Mac address (All line below shall be consistent):
- Displayed on the back label and on side label.
- use by the module on Ethernet
04
Interface Counters


-
05
Media Counters


-
06
Interface Control


Current configuration
07
Interface Type


Twisted-Pair
The I/F is internal to the device
08
Interface State


The interface is enabled
09
Admin State


Enable the interface
10
Interface Label


ETH1
ETH2
Internal Port
11
Capabilities


100, Half (0) / 100, Full (1)
100, Full (1)
 Supported  Not supported
Instance Services
Id
Service
Param. Options
01h
Get_Attributes_All
0Eh
Get_Attribute_Single
10h
Set_Attribute_Single
4Ch
Get_and_Clear