4 • 157
Appliances
2004 • LaPalma
• ON/OFF Button - Turns the refrigerator on or off.
- Push the ON/OFF button to start the refrigerator in Auto mode.
- Push and hold the ON/OFF button for two seconds to shut it off.
• TEMP SET Button - Adjusts the temperature.
- To adjust push and hold the TEMP SET button.
- Number "9" is the coldest setting.
• MODE Button - Controls the operation mode of the refrigerator.
- Push and hold the MODE button to select between Automatic
AU, AC or LP operation.
Manual Mode:
When one of the two manual modes is selected:
1. AC = The refrigerator is operating on AC electric.
2. LP = The refrigerator is operating on LP-Gas.
Automatic Mode:
The refrigerator selects AC power over LP-Gas in Auto mode (AU).
The controls select the energy source in this sequence.
1. When 120 Volts AC is available "AU AC" flashes in the display.
This indicates the refrigerator is operating on AC electric. After ten
seconds, the "AU AC" goes off and only a power indicator remains.
2. If 120 Volts AC is not available, "AU LP" flashes in the display. This
means the refrigerator is operating on LP-Gas.
3. After the refrigerator is operating, press the TEMP SET button and set
the desired temperature.
If the LP-Gas does not ignite within 30 seconds, the control changes
to a different energy source or the gas safety valve closes and F displays.
Turn the refrigerator off then back on. If the gas does not ignite after
several attempts, consult a dealer or authorized Norcold service center.
030864C
Control Panel
- Two Door
To Next Page
Loading...
