5 • 207
Equipment
2004 • LaPalma
Retracting
Bedroom Slide-out
To Extend the Bedroom Slide-out:
• Confirm that there is at least five feet of clearance outside the
motorhome for the slide-out room to extend.
• If applicable, remove locking bar mechanisms on top of the
slide-out room inside the motorhome.
• Press and hold the slide-out room switch in the OUT position. The
switch is located on the systems monitor panel or in the bedroom.
The slide-out room will slowly move to the OUT position. Release
the switch to stop room movement. To continue the room
movement, push and hold the switch in.
• Release the switch, which will lock the room in position.
CAUTION: Dirt and grit trapped under the slide could result
in damage to the floor. Continuous operation of the slide-out
could cause a drain on the house batteries and/or damage to
the slide motor.
CAUTION: If applicable, remove the slide lock bars before
moving the slide-out room. Damage can result if bars are left
in position. The manufacturer is not responsible for damage
resulting from operating the slide-out room with the slide lock
bars left in the locked position.
NOTE: Do not leave the slide-out in the extended position
during severe weather. Conditions such as high winds or
heavy rain may cause damage to an extended slide-out.
NOTE: Extensive damage could occur to the slide room and
awning when extending the slide room in snow, sleet, ice, or
freezing rain conditions. In such conditions, if the slide-out
room is already extended, clear the awning and ensure free
movement prior to operating the slide room.
To Retract the Bedroom Slide-out:
• Ensure there is sufficient clearance inside the motorhome for the
slide-out room.
• If applicable, clean floor.
• Remove any debris from the top of the slide-out room.
• Press and hold switch to the IN position. To stop the slide-out room
before it fully retracts, release the switch. To continue the room
movement, push and hold the switch in.
• When the room is fully retracted, release the switch. The room will
lock into position.
• After the slide-out room is retracted, if applicable, place locking
bar mechanisms between the wall and top edge of the slide-out
room and lock into place.
Extending Bedroom
Slide-out
To Next Page
Loading...
