2 • 40
2004 • LaPalma
Driving & Safety
Refueling:
• Truck stops are good refueling points for motorhomes.
• For your convenience there is a fuel port located on either side,
near the front of the motorhome.
• Check overhead clearance heights before pulling through the
fuel island.
• Be aware of the concrete/steel posts installed around the fuel
island.
• Avoid running over the fuel hose as it can get hung up on the
motorhome, causing body damage.
• Use of gloves is recommended for refueling. Store the gloves in
the outside compartment.
WARNING: Avoid the risk of fire or explosion. Turn off all pilot
lights and appliances before entering a refueling station.
Unit has two buttons, “MODE” and “F/C”, which are used to change the
unit between various operations.
Ignition ON Operation:
• Unit displays temperature and heading.
• Press the F/C button to toggle between Fahrenheit and
Centigrade.
• When unit has been properly calibrated, the heading will remain
ON. If the unit is not properly calibrated, the work CAL will
flash.
Calibration/Zone Procedures:
• Press and hold the MODE button for 10 seconds until the words
ZONE and CAL appear. The unit will display the current zone
value.
• Press the F/C button to increment the zone value.
• Press the MODE button to store the zone value.
080268b
COMPASS &
OUTSIDE
TEMPERATURE
SYSTEM
To Next Page
Loading...
