Maintenance
2 • 97
Driving & Safety
A smoke alarm is designed to be as maintenance free as possible. However,
there are some simple steps to perform in order to keep the smoke alarm
working properly:
• Test the smoke alarm once a week.
• Keep a supply of 9 Volt DC batteries on hand.
• Vacuum the slots in the cover and sides with a soft brush attach-
ment every month. Test the smoke alarm once the unit has been
vacuumed.
• The smoke alarm should be cleaned every six months to help keep
the unit working efficiently.
• The smoke alarm will beep once a minute when a low battery
condition exists. The battery must be replaced immediately.
If the alarm does not sound when the test button is pushed, or with a smoke
test, try the following:
• Inspect for obvious damage.
• Check for the recommended battery type.
• Check the battery for proper connection or replace the battery if needed.
• Gently vacuum as recommended.
If these procedures do not correct the problem, do not attempt repairs. If the
smoke alarm is within the warranty period and the terms indicate the nature of
the problem, return the unit to your dealer. Smoke detectors beyond the
warranty period cannot be economically repaired.
2004 • LaPalma
Troubleshooting
To Next Page
Loading...
