8 • 337
Electrical Systems
2004 • LaPalma
To Coast:
The COAST switch on steering wheel will allow the motorhome to coast
or slow in speed. When the COAST switch is pressed and held the
motorhome will slow in speed. When released the motorhome programmed
set speed will automatically set to the adjusted coast speed.
To Disengage:
The cruise can be disengaged by two methods, simply press the brake
pedal and the current programmed speed is canceled. Pressing and releasing
the ON/OFF switch on steering wheel will erase the programmed speed and
turn OFF the cruise function.
To Resume:
When disengaging the system with the brake does not erase the set speed
from memory even if a complete stop is reached. To return to the chosen
speed drive to a speed above 30 mph then push the RESUME switch on
steering wheel. The speed control program will return to that original set speed.
If the rate of acceleration is faster or slower than desired, use the accelerator
to obtain a speed close to pre-set speed then push the RESUME switch. The
cruise control will automatically turn off when ignition switch is disengaged.
The control for the steering wheel tilt is a lever located on the steering
column near the dash. Pulling the lever will allow changes to be made in the
tilt of the steering wheel. Adjust the wheel to the desired position then
release the lever.
When the end of the arm is pressed in washer fluid
will be dispensed from the system and the wipers will turn
on momentarily. Holding the tip, pushed in, fluid will
continue to be dispensed until the tip is released.
Wiper operations are controlled when rotating the end
of the arm. When the end of the arm is rotated from OFF
to DELAY the wipers will turn on and a time delay
between wipes (ranging from 45 seconds to 2 seconds)
will occur. The amount of delay time changes as arm end
is rotated. A continuous low or high speed can be
obtained by rotating the arm end to appropriate position.
The wipers will be turned OFF with the switch in the
OFF position.
Tilt Steering
Wiper/Washer Operation
OM090292C
To Next Page
Loading...
