8 • 308
2004 • LaPalma
Electrical Systems
The remote panel monitors the inverter status and is used to change
variable settings. The panel uses LED lights to monitor values when hooked
to shore power, inverting or in the set-up mode.
LED indications when hooked to Shore Power:
• DC Volts represents DC output voltage at the inverter.
• DC Amps represents the amount of DC charge current.
LED indications when Inverting:
• DC Volts represents DC battery voltage at the inverter.
• DC Amps represents the amount of DC discharge current.
LED indications when in Set-up Mode:
(Press and hold SET-UP for five seconds):
• DC Volts represents the amount of Amp Hours of the battery bank.
• DC Amps represents the amount of load (measured in watts) needed to
activate the inverter.
• Incoming AC Breaker Amps represent battery type and operating
temperature.
Remote Panel
060169
To Next Page
Loading...
