Two methods can be used to monitor the amount of fuel in the LP-Gas
tank. A small gauge is located on the LP-Gas tank. This non-adjustable gauge
provides a quick view of the tank capacity. The monitor panel in the hallway
also measures the LP Gas level of the tank. To check the LP tank level, push
test button on the display panel. Lights on panel will turn on in sequence
indicating level of tank. The lights and scale indications are as follows:
• Green lamps indicate good or
normal ranges.
• Amber lamps indicate fair or
partial ranges.
• Red lamps indicate full or empty
ranges (depending on the scale),
which are in the critical range.
NOTE: This chart reflects product specification available at
the time of printing. Therefore any floor plans thereafter
may not be reflected in the chart. All other information
contained throughout the manual will still apply.
NOTE: All tank capacities are estimated based upon
calculations provided by the tank manufacturers and
represent approximate capacities. The actual “usable
capacity” may be greater or less then the estimated
capacities based upon fabrication and installation of the
tanks.
7 • 275
LP-Gas System
2004 • LaPalma
LP-GAS TANK
- MEASUREMENT
050256
LP Tank Gauge
To Next Page
Loading...
