8 • 341
Electrical Systems
2004 • LaPalma
To Resume - Disengaging system with the brake does not erase set speed
from memory, even at a complete stop. To return to the chosen speed, drive
to a speed above 25 mph, then move slide button to Resume/Accel position
and release. Speed control will return to the original set speed. If rate of
acceleration is faster or slower than preferred, use accelerator to obtain a
speed close to set speed, slide button to Resume/Accel position and release.
There is no drain on battery when ignition switch is off, even if cruise is left
on.
To Next Page
Loading...
