User Manual
26
Total: set up pre-set bit quantity
Pre: indicates starting point cruised. System default point is 01.
STP：sets the stop time at each point
: allow you go to a specific preset point.
: allow you set a set of specific preset points of a PTZ camera.
1. Select a camera you desire to set a preset point;
2. Adjust the camera in a desired direction
3. Click [Set] to set the point as preset point
4. Click [Save] to save the preset point
5. Follow the above steps to add one more preset point.
: allow you delete one selected preset.
: allow you save relative parameters
: allow you exit PTZ control interface
Note: Up to 255 preset bits for the DVR can be stored. However, actual preset quantity differs depending
on PTZ performance.
5.7 Record
Enter into Pop-up menu to select the [Record] option. Now you can start manual record function, or you
also can click [Rec.] button on the Front panel or Remote controller to activate manual record. Please stop
record manually once you activate manual record.
5.8 Stop Record
To stop record quickly, please enter into pop up Menu to select [Stop] option.
To Next Page
Loading...
