Moog G394-030

moog
MSD Servo Drive Compact Operation Manual
9
[ Safety ]
to the glossary
to the table of contents
Id no.: CA97555-001, Rev. 3.0 - Date: 0 6/2012
1 Safety
1.1 For your safety
The instructions set out below should be read through prior to initial commissioning
in order to prevent injury and/or damage to property. The safety instructions must be
followed at all times.
ATTENTION! The MSDServoDriveCompact‘s “Safe Torque Off (STO)” safety
function must be approved by the TÜV-Rheinland accredited certification
body. This certification is currently still in preparation. Conformance to parts
of ENISO13849-1, EN62061, EN61800-5-1 and EN61508 is ensured.
!
1.1.1 Read the Operation Manual first!
1.
Read the Operation Manual first!
• Follow the safety instructions!
• Refer to the user information!
Electric drives are dangerous:
• Electrical voltages of 230V to 480V
Dangerously high voltages of ≥ 50V may still be present 10
minutes after the power is cut (capacitor charge). So check
that the power has been cut!
• Rotating parts
• Hot surfaces
Protection against magnetic and/or electromagnetic fields during installation
and operation.
• Persons fitted with heart pacemakers, metallic implants and hearing aids
etc. must not be allowed access to the following areas:
− Areas where drive systems are installed, repaired and operated.
− Areas where motors are installed, repaired and operated. Motors with
permanent magnets pose a particular hazard.
NOTE: If it is necessary to access such areas, suitability to do so must be
determined before hand by a doctor.
Your qualification:
• In order to prevent personal injury or damage to property, only
personnel with electrical engineering qualifications may work on the
device.
• The said qualified personnel must be familiar with the contents of the
Operation Manual (cf. IEC364, DINVDE0100).
• Awareness of national accident prevention regulations (e.g. BGV A3 in
Germany)
During installation observe the following instructions:
• Always comply with the connection conditions and technical
specifications.
• Comply with the standards for electrical installations, suchas regarding
wire cross-section, grounding lead and ground connections.
• Do not touch electronic components and contacts (electrostatic
discharge may destroy components).
Table 1.1 Safety instructions