16
SEQUENCER PANEL CONTROLS (continued)
PATTERN (BANK)
This button is used to view the currently active pattern location, or select a
new pattern. While holding the (SHIFT) button, it is used to view the current
Bank containing 8 patterns, or select a new Bank.
RUN/STOP (REC)
This button is used to start the Sequencer, and to stop it. While holding the
(SHIFT) button, this is used in Keyboard mode to initiate the Record function.
NOTE: Holding (SHIFT)+(REC) for over a second will start the saving process.
(SHIFT)
When pressed and held, this button is used in conjunction with other buttons
to perform various functions.
RESET/ACCENT
When the Sequencer is running, this button is used for resetting the step
location of a pattern to Step 1. When editing a step it is used to enable or
disable an Accent output.
HOLD/REST
When the Sequencer is running, this button is used for repeating the current
step at the current tempo as long as it is held down. When editing a step it is
used for enabling or disabling a Rest.
SHIFT FUNCTIONS: SWING AND RATCHET
Sequencer functions Swing and Ratchet are accessed by pressing (SHIFT)+ rotating the TEMPO
control for varying Swing, or by pressing (SHIFT)+ rotating the GLIDE control for setting Ratchet
values. Swing sets a percentage that the off beats are ahead or behind the beat. Ratchet species
a number (1-4) of note-repeats occurring during the length of a single step.
NOTE: When (SHIFT) is released after modifying Swing or Ratchet values, the position of the GLIDE and
TEMPO controls may not match their actual current values. As these controls are moved, the actual value
chases the current position of the control until it catches up.
To Next Page
Loading...
