Disassembly/Reassembly Procedures: Radio Reassembly 7-21
7.6.2 Reassemble the Keypad Board (10) and Keypad Flex (11)
1. With the Keypad (8) assembled, gently lift the Front Kit Flex and place the Keypad Board (10)
into the Front Housing.
Figure 7-26. Plug in the Front Kit Flex Connector
2. Gently rest the Front Kit Flex onto the Keypad Board (10).
3. Place the Keypad Flex (11) in position and gently plug the Keypad Flex connector to the
Keypad Board.
NOTE: Plug in the connector at the side of the Keypad Flex which reads “To Keypad Board”.
Figure 7-27. Rest the Front Kit Flex and plug in the Keypad Flex Connector
When plugging in the connectors, care is needed to avoid
damage to the interconnect and surrounding on-board
components.
To Next Page
Loading...
