7-22 Disassembly/Reassembly Procedures: Radio Reassembly
7.6.3 Reassemble the Keypad Retainer (12)
1. Place the Keypad Retainer (12) over the Keypad Board (10) in the Front Housing (2) as
shown in Figure 7-28.
Figure 7-28. Place Keypad Retainer over the Keypad Board
2. Torque all four keypad retainer screws (13) with a Torx IP6 Bit and a Torque Driver to 1.2 in-
lbf in the sequence as shown in Figure 7-29.
Figure 7-29. Torque in the Keypad Retainer Screws
To Next Page
Loading...
