CHAPTER 3 USER PREFERENCES
Introduction
This chapter describes each user preference feature and provides the programming bar codes for selecting
these features for the scanner.
The scanner ships with the settings shown in the User Preferences Default Table on page 3-2 (also see
Appendix A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the
default values suit the requirements, programming is not necessary. To change these values, scan a single bar
code or a short bar code sequence. After scanning Save Configuration on page 3-24, the new settings are
stored in non-volatile memory and are preserved when the scanner powers down.
To return all features to their default values, scan the Reset Factory Defaults bar code on page 3-4. Throughout
the programming bar code menus, default values are indicated with asterisks (
*).
Scanning Sequence Examples
In most cases, scan only one bar code to set a parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code under Beeper Tone on page 3-13. The scanner issues a fast
warble beep and the LED turns green, indicating a successful parameter entry.
Other parameters, such as Data Transmission Formats, require scanning several bar codes. See the
parameter description for this procedure.
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.
*Medium Frequency
(1)
Feature/Option* Indicates Default
Option value
To Next Page
Loading...
Need help?
General
