10 - 8 WT4070/90 Wearable Terminal Integrator Guide
Wearable terminal turns
itself off.
Wearable terminal is
inactive.
The wearable terminal turns off after a period of inactivity. If the
wearable terminal is running on battery power, this period can
be set to 30 sec., 1, 2, 3, 4, 5 or 6 minutes. If the wearable
terminal is running on external power, this period can be set to
1, 2, 3, 5, 10, 15 and 30 minutes.
Check the power settings by selecting
Start
>
Settings
>
Control Panel
>
Power
icon >
Power Off
tab.
Change the setting if you need a longer delay before the
automatic shutoff feature activates.
Voice Only WT4090
was set to suspend.
Return Voice Only WT4090 suspend setting to factory default
(disabled).
Battery is depleted. Replace or recharge the battery.
Battery is not inserted
properly.
Insert the battery properly (see
Installing and Removing the
Main Battery on page 1-4
).
The wearable
computer’s battery is
low and it powers
down to protect
memory content.
Replace or recharge the battery.
A message appears
stating that the wearable
terminal memory is full.
(not applicable to voice
only configuration).
Too many files stored
on the wearable
terminal.
Delete unused memos and records. You can save these
records on the host computer.
Too many applications
installed on the
wearable terminal.
If you have installed additional applications on the wearable
terminal, remove them to recover memory.
Select
Start
>
Settings
>
Control Panel
>
Remove Programs
icon.
Select the unused program and select
Remove.
Table 10-1
Troubleshooting the Wearable Terminal (Continued)
Problem Cause Solution
To Next Page
Loading...
