Chapter 1
Set-up
Unpacking Your Unit
Several cartons may arrive with your order; locate the carton(s)
marked as the Toxgard II Monitor. Upon receipt, ensure that your
package contains:
• Toxgard II Monitor (FIGURE 1-1)
• Toxgard II Monitor Instruction Manual (P/N 711266).
If your unit is a Toxgard II Monitor with Digital Output,
there will be an additional manual (P/N 711203)
• Toxgard II Remote Sensor Module, if ordered as a
Remote Sensor model (FIGURE 1-2)
1. Remove the Toxgard II unit from its shipping container(s),
taking care not to damage sensitive electrical components.
2. Search through the packing material and the containers to
avoid discarding valuable parts.
Initial Inspection
1. Turn the coin slot lock 1/4-turn clockwise and open the door
or use the key for the key lock, if so equipped.
2. Carefully inspect the components and assemblies inside the
case. If damage or shortage is noted, advise the carrier
promptly; make the proper claim with the carrier.
General Description
The Toxgard II Monitor is an easy-to-use, low-cost, one-sensor
monitor. It is designed to sample the environment where the
monitor is mounted and to alert you to potentially dangerous
levels of one of the following gases, depending on your
particular model:
• Combustible gas • Hydrogen Cyanide
• Oxygen • Hydrogen Chloride
• Carbon Monoxide • Nitric Oxide
• Hydrogen Sulfide • Nitrogen Dioxide
• Chlorine • Sulfur Dioxide
• Chlorine Dioxide
Chapter 1, Set-up
1-1
To Next Page
Loading...
Need help?
General
