MST Impact NS5004 User Guide

5.5 Settings Tab
5.5.1 Managing Automatic TFTP Configuration
The Cong Management screen is used to congure how the device retrieves its conguration from a
TFTP server on the network. For more information on TFTP, see Centralised Conguration Management
on page 85.
Note: These settings only affect TFTP conguration from a ICA v1.3.1 or earlier, and 3rd party
TFTP servers. If using AP Cong Templates from ICA 1.4.0 or later, leave Self check disabled
(See Device Management Overview on page 86).
Self Check Settings
To enable automatic conguration from a TFTP server, tick the Self check enabled checkbox, enter the
desired Self check interval and TFTP Server Address, then click the Save Settings button.
Change Numbers
The two change numbers shown here are timestamps (formatted as YYYYMMDDhhmmss) showing the
last time the device's settings were updated via TFTP. The Site Change Number refers to general site
settings applied to all devices, whereas the Device Change Number refers to specic settings applied to
this device.
5.5.2 Configuring SNMP Settings
The SNMP screen contains Simple Network Management Protocol settings. SNMP is a protocol used by
the ICA and 3rd party SNMP browsers to monitor the status of compatible devices on the network. At
present, the ICA only uses this protocol to monitor for Port Up/Port Down errors on the NS50, and is not
affected by the settings below.
Revision C66NS50 User Guide
Conguration Using the Web Interface

MST Impact NS5004 Specifications

General

Brand	MST
Model	Impact NS5004
Category	Switch
Language	English