EasyManuals Logo

MST Impact NS5004 User Guide

MST Impact NS5004
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
AG with Dynamic Turbo enabled. In Turbo mode, the access point doubles the channel bandwidth to
increase the throughput.
Super AG with Static Turbo Channel 6 ONLY - Capable of Packet Bursting, FastFrames,
Compression, and Static Turbo. This setting is not backwards compatible with non-Turbo (legacy)
devices. Static turbo mode is always on and is only enabled when all devices on the wireless network
are Super AG with Static Turbo enabled.
Channels
It is recommended that WACs in proximity of each other have different wireless channels (for example,
channels 1, 6 and 11). This minimises signal overlap and the possibility of interference.
Advanced Wireless Settings
Recommended SettingsDescriptionField
Default setting is at the
maximum size of 2346 and is
Maximum frame size that can be sent without
fragmentation.
Fragmentation
Threshold
recommended for most
environments.
Default setting is 2346.Determines what size data packet the low level RF
protocol issues to an RTS packet.
RTS threshold
Default setting is 100ms.The amount of time between beacon transmissions.Beacon Period
The recommended DTIM
interval is 1.
A DTIM is a countdown informing clients of the next
window for listening to broadcast and multicast
messages. Wireless clients detect the beacons and
DTIM interval
awaken on the DTIM interval to receive the broadcast
and multicast messages. Valid settings are between
1 and 255.
Default 3000μs (0.3s)The time in microseconds which will be used to send
data without stopping. Note that other wireless cards
Burst Time
in that network will not be able to transmit data for
this period.
802.11d is not enabled by
default.
Wireless specication where conguration occurs
at a MAC layer level to comply with country or
district rules.
802.11d enable
5.5.5 Configuring Wireless Networks
A WAC can have up to four wireless SSIDs with different performance and security settings. Each can
be mapped to different VLANs.
NS50 User Guide71Revision C
Conguration Using the Web Interface

Table of Contents

Other manuals for MST Impact NS5004

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MST Impact NS5004 and is the answer not in the manual?

MST Impact NS5004 Specifications

General IconGeneral
BrandMST
ModelImpact NS5004
CategorySwitch
LanguageEnglish

Related product manuals