MST Impact NS5004 - Centralised Configuration Management

Wireless Radio and Networking
• wireless.radio.1.* - General wireless radio settings.
• wireless.radio.1.ap.x.* - Each WAC in a device can have up to four wireless SSIDs (where "x" is
replaced with 1-4), each with different security settings and different VLAN mapping.
• wireless.radio.1.ap.x.wep.* OR wireless.radio.1.ap.x.wpa.* - WEP/WPA security; only the options
specic to the enabled security mode need be congured.
Wireless EAP Configuration
• wireless.eap.* - RADIUS server settings. This is applicable only to wireless networks congured with
WPA Enterprise security mode.
• wireless.eap.x.* - A primary and secondary (backup) RADIUS server can be set up and congured.
The "x" in each parameter should be replaced with "primary" or "secondary".
WDS (Wireless Distribution System)
• wireless.radio.1.wds.* - Allows ImPact network devices to connect wirelessly where a bre or ethernet
connection is not practical.
• wireless.radio.1.wds.peer.x.* - Up to six peered devices can be congured; "x" is replaced with 1-6.
Switch Configuration
• switch.port.x.* - Controls switch ports 1-8 and assigns VLANs; "x" is replaced by the relevant port
number.
PoE (Power Over Ethernet)
• switch.poe.enabled - Controls the 48VDC PoE supply feature, and is enabled by default.
Revision C92NS50 User Guide
Centralised Conguration Management