MTD 700 Series - Page 162

700 Series Lawn Tractor
156
NOTE: When reassembling the pulleys and belt
guards, note that the guard may have a
coined protrusion that fits into a hole on the
idler bracket. This properly aligns the belt
guide.
See Figure 8.13.
4. Route the new belt around the pulleys. Refer to the
Operators Manual or belt routing label on the deck
for proper routing diagram.
• For a 38” deck, See Figure 8.14.
• For a 42” “G” deck and a 46” “T” deck,
See Figure 8.15.
Figure 8.13
Alignment protrusion and hole
Figure 8.14
Figure 8.15
FOR DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com