EasyManuals Logo

Muller Elektronik TRACK-Guide III User Manual

Muller Elektronik TRACK-Guide III
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Basic control principles
Switching the display to ON.
5
31302713-02-US
V9.20191001
17
Basic control principles
Switching the display to ON.
To switch on the display:
The display is installed and connected to the power cable or the ISOBUS basic vehicle harness.
1. Press and hold the
button for approx. 3 seconds.
The display will beep briefly.
The display screen remains dark for approx. 10 seconds until the applications are loaded in
the background.
The start-up screen of the display will appear:
You have now started the display.
Initial start-up
The next step to perform after switching on the display depends on the purpose of the display:
Parallel guidance
Operation of ISOBUS implements
Automatic boom section control
Task management and documentation
These cases will be described in the following sections.
Using the display for parallel guidance
If you want to use the display for parallel guidance, TRACK-Leader is the most important app for you.
Most important settings
Setting
Where?
Purpose
Select the GPS driver.
/ Driver / GPS [ 26]
The standard driver works in
most cases for the receivers
sold by ME. However, to
change the correction signal, a
fitting driver for the GPS
receiver must be activated.
5
5.1
Procedure
5.2
5.2.1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Muller Elektronik TRACK-Guide III and is the answer not in the manual?

Muller Elektronik TRACK-Guide III Specifications

General IconGeneral
BrandMuller Elektronik
ModelTRACK-Guide III
CategoryAutomobile Electronics
LanguageEnglish