7
Configuring the display in the Service application
Changing the language
Configuring the display in the Service application
Changing the language
If you change the language in the Service application, you also change the language for all
applications and the ISOBUS job computer.
If a connected ISOBUS job computer cannot activate the selected language, a standard language will
be activated.
1. - Open the Service application.
⇨ The application start screen will appear:
2. Tap "Terminal".
⇨ A list of parameters will appear.
3. Slide your finger over the display screen from the bottom to the top.
⇨ New parameters appear.
4. Tap "Language" (“Sprache”).
⇨ A list of abbreviations of available languages will appear.
5. Tap the abbreviation for your language.
⇨ The abbreviation is marked with a green dot.
6.
- Confirm.
⇨ The "Terminal" screen will appear.
7. Restart the display.
Basic display settings
The basic settings include: Language, Time, Measurement units.
All settings which you make here will also apply to other applications and in connected ISOBUS job
computers.
1. - Open the Service application.
To Next Page
Loading...
Need help?
General