Connecting and configuring external devices
Crop protection sensors
6
1. Connect the sensor to the ISOBUS.
2. Follow the instructions from the sensor manufacturer. The display does not need to be
configured.
To work with serial connection sensors:
1. Connect the sensor to the serial port of the display.
2. Create a virtual job computer in the Virtual ECU app. [➙ 60]
3. In the "External controller" [➙ 61] parameter, select the sensor type.
4. Activate the job computer for the sensor.
⇨ You have activated the sensor.
⇨ The display transmits all target rates to ISOBUS-TC, the ISOBUS job computer and TRACK-
Leader.
Special case
If you are working with your machine in mixed operation, with ISOBUS and serially connected
sensors, you must observe the following sequence:
The serial sensor is connected to the serial interface of the display.
1. Connect the ISOBUS components to the ISOBUS.
2. Start the Virtual ECU [➙ 60] app.
3. Create a virtual job computer in the Virtual ECU app. [➙ 60]
4. In the “External controller” [➙ 61] parameter, select the sensor type.
5. Activate the job computer for the sensor.
⇨ You have activated the sensor.
6. Set the connectors in the list of connections.
⇨ The display transmits all target rates to ISOBUS-TC, the ISOBUS job computer and TRACK-
Leader.
To Next Page
Loading...
Need help?
General