Configuring the display in the Service application
Using the Open Data Interface
7
Examples: Transmitting tasks to the ISOBUS-TC, sending target rates to the job computer, etc.
Activating ME ODI
Please note that you can only activate the driver for ME ODI if the driver for farmpilot is deactivated.
To activate ME ODI:
1.
- Open the “Service” application.
2. Tap “Driver”.
3. Tap “Open Data Interface”.
⇨ The installed drivers appear.
4. Tap “ME ODI”.
5.
- Confirm.
6. Restart the display.
Opening ME ODI
To open ME ODI:
1.
- Open the “Service” application.
2. Tap on “...”.
3. Tap “Open Data Interface”.
⇨ The “Settings” screen appears.
The overall configuration of the connection must take place through the online service. On the
“Settings” screen, you can see information on the established connections:
▪ “Client” - Services that are presently connected to the display.
▪ “Diagnostics” - Here, you can record the connection sequence to be able to find the cause in
case of an error.
To Next Page
Loading...
Need help?
General