60 Part Number 9294699 12/16/15
Maintenance Section 4
Auto Prime Complete
1. Remove and dispose of large cup with primed product.
Important
Do Not pour down the drain on the BIC unit!
2. Press the Green Check to continue to the Dispensing
Area Cleaning screen.
Dispensing Area Cleaning
Important
Do Not Insert a brush or sharp object into the red
dispense nozzles.
1. Remove center grate from dispensing area.
2. Spray all dispensing area surfaces with cleaning
solution. Then use approved cleaning brush to
thoroughly scrub area.
3. Thoroughly spray each individual dispense nozzle
with cleaning solution and apply cleaner to each
individual dispensing valve. Then use brush to
carefully scrub the area.
• Press the Down Arrow to continue.
4. Thoroughly wipe all dispense valves and dispense area
with a clean towel.
• Press the Down Arrow to continue.
Dispensing Area Sanitizing
1. Thoroughly spray each individual dispensing nozzle
with sanitizer solution.
2. Thoroughly spray dispense area with sanitizer solution.
3. Allow to air dry.
4. Do not wipe off sanitizer!
• Press the Green Check to continue.
Product Line Flush Completed
1. Take dispense area grate to sink to wash and sanitize.
2. Reinstall dispense area grate.
3. Remove gloves and safety glasses.*
4. Clean, Rinse, Sanitize, and Dry any equipment before
storing in a safe, protected location.
5. Press the Green Check to complete Product Line Flush.
The screen will return to the Main Menu.
To Next Page
Loading...
Need help?
General
