MULTIQUIP Rammax RX1575 - Page 102

PAGE 102 — RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL S/N 3069933~ — REV. #0 (11/29/23)
MAINTENANCE
112 RAMMAX1575
555085
1
555085
1
557017A
2
3.6 Individual Operations of Maintenance
Draining the hydraulic oil
Note
• Only drain the hydraulic oil at operating temperature.
• Residues in the tank will be ushed out with the oil.
• Place acontainer (with at least a30 liter capacity) under the
hydraulic oil drain.
• Remove the hydraulic oil tank lid (1).
• Remove the plug (2) from hydraulic tank.
• Allow the oil to drain into the container.
• Install the screw plug (2).
• Tighten the screw connection hand tight.
• Tighten the screw connections in the hydraulic tank hand
tight.
Filling the hydraulic circuit:
• Fill hydraulic oil through the port into the tank.
• Replace the venting lter (1) for a new one.
Breather lter
Order number: 1242184
• Apply thin lm of oil on the sealing ring in the lid.
• Install new lter in the tank.
Exchange oil when it is warm, preferably after the ma-
chine stops.
Let drained oil cool down to less than 50°C (122°F).
Rell the identical type of oil.
Avoid leakage of oil to the soil.