Multitech MultiConnect rCell 100 User Manual

SETTING UP CELLULAR FEATURES
MultiConnect
®
rCell 100 MTR-EV3 User Guide 53
Chapter 10 – Setting Up Cellular Features
Configuring Cellular
To configure how cellular is used on your device:
1. On the Web Management interface, go to Cellular > Cellular Configuration to display the Cellular
Configuration window. If you choose IPv6 Passthrough mode, you must select Administration > Initial
Setup.
2. Check Enabled.
3. Check and change the Cellular Configuration fields as desired. For field descriptions, see Cellular
Configuration Fields.
4. Click Submit.
5. To save your changes, click Save and Restart.
Cellular Configuration Fields
Field Description
General Configuration
Enabled Allows the device to establish a cellular connection (Cellular WAN).
Dial-on-Demand
1
Enables the Dial-on-Demand feature. If enabled, the device brings up and
maintains a cellular connection while network activity on the LAN requires
WAN access. The device brings down the cellular connection when outgoing
network traffic ceases for the given Idle Timeout duration. Enable this
feature when Wakeup-on-Call is enabled to allow the device to "sleep" after
it has been "woken up." See Configuring Wakeup-on-Call for more
information.
Diversity Allows the use of two antennas to increase receive signal quality. Not all
models support diversity. If diversity is enabled, connect a second cellular
antenna to the AUX port on the device. Otherwise, the cellular performance
of the device may degrade.
Connect Timeout The time (in seconds) that the device waits before it deems that the
connection attempt has failed. The value used is the amount of time that
elapses between each dialing retry.
Dialing Max Retries Number of dialing retries allowed; the default is zero, which means an
infinite number is allowed.
Modem Configuration
Dial Number The modem dial string is:
*99***1# for GSM/GPRS/non-Verizon LTE devices
#777 for CDMA/EVDO devices
Connect String The modem response to initiate a PPP connection, usually CONNECT.
Dial Prefix The modem AT command that initiates a PPP connection, usually ATDT or
ATD.

Multitech MultiConnect rCell 100 Specifications

General

Brand	Multitech
Model	MultiConnect rCell 100
Category	Network Router
Language	English