Multitech MultiConnect rCell 100 - Uploading CA Certificate; Setting up the Remote Management; Managing Your Device Remotely

DEVICE ADMINISTRATION
84 MultiConnect
®
rCell 100 MTR-EV3 User Guide
5. To save your changes, click Save and Restart.
Uploading CA Certificate
This page allows a user to upload an X.509 CA (Certifying Authority) Certificate.
To upload a CA certificate:
1. Go to Administration > X.509 CA Certificates.
2. Click Choose File and browse for your CA certificate file.
3. Click Open.
4. Once your file is selected, click Import.
5. Your CA certificate file displays in the certificate list along with relevant details.
6. You may delete or remove a certificate by clicking the trash can icon to the right under Options.
Note: It can take up to two minutes to add or remove a certificate. The changes are applied immediately and there
is no need to restart the device after CA certificate is added or removed.
Setting up the Remote Management
To modify DeviceHQ automatic update settings, go to options under Auto-Update Settings and refer to Managing
Your Device Remotely.
1. Go to Administration > Remote Management > Remote Server. To allow the device to connect to the
Remote Management Server, check Enabled.
2. If you want the device to use a secure connection, check SSL Enabled.
3. The Server Name field is pre-populated with the address of the Remote Management Server.
4. The Server Port field is pre-populated with the port the Remote Management Server listens on. You likely
do not need to change this.
5. In the Account Key field, type the account key received from the Remote Management administrator.
The device is not allowed to connect to the Remote Management Server without a valid account key.
6. Click Submit.
7. To save your changes, click Save and Restart.
Managing Your Device Remotely
DeviceHQ can monitor devices, reboot devices, and perform remote software and configuration updates.
To configure your device to use DeviceHQ:
1. Go to Administration > Remote Management and check Enabled. See other options under Setting up the
Remote Server.
2. Go to options under Auto-Update Settings.
3. To define how often the device connects to DeviceHQ to check in and request any pending updates, set
the Check-In Interval field to the desired number of minutes between 240-10080 (240 minutes to 1
week).
Note:
Your device must connect to DeviceHQ every 4 hours at a minimum. If you set the check-in interval to
less than 4 hours, your change is ignored.