DEVICE ADMINISTRATION
MultiConnect
®
rCell 100 MTR-EV3 User Guide 77
a. Username (required)
b. Role (required). Select the user role from the drop-down menu including administrator, engineer, or
monitor.
c. First Name
d. Last Name
e. Title
f. Division
g. Employee Identification
4. Under Contact Information, enter the following fields:
a. Email
b. Address
c. City
d. State
e. Country
f. Postal Code
g. Work Phone
h. Mobile Phone
5. Click Submit.
6. The Change Password page opens. Enter New Password. Click Submit.
7. The Change Password page opens. Enter New Password. Click Submit.
If the password is not set up for the new user, the user is disabled until the password is set.
Self-Diagnostic
The device offers self-diagnostics or periodic monitoring of certain issues such as: flash memory checksums,
memory errors or leaks, and security violations by applications.
This monitoring is intended to improve performance, detect corruption, or help prevent malicious activity. After an
event is detected, the system disables the cellular radio module, sends an alarm or notification, logs the event, and
sends a record of it to the SNMP server.
For the self-diagnostic features, go to Administration > Self-Diagnostic and refer to the following sections.
To turn on the Resource Overuse diagnostic that detects memory leaks or errors:
1. Check Enabled under Resource Overuse.
2. If you want the system to reboot the device after a Resource Overuse is detected, check Reboot the
device under Actions.
To turn on the Security Violation diagnostic that detects security rule violations by applications:
1. Check Enabled under Security Violation.
2. If you want the system to disable WAN interfaces after a Security Violation is detected, check Disable
WAN Interfaces under Actions.
3. If you want the system to disable user-defined firewall rules after a Security Violation is detected, check
Disable User-Defined Firewall Rules under Actions.
To Next Page
Loading...
Need help?
General
