DEVICE ADMINISTRATION
92 MultiConnect
®
rCell 100 MTR-EV3 User Guide
b. Navigate to the location where you wish to save the file and select location.
4. This option is only available if you had reset to user-defined configuration. (Also, holding the reset button
on the device for 30 seconds overrides user-defined settings and resets to factory default.) To reset the
device's configuration to the factory settings, go to Reset to Factory Default Configuration:
a. Click Reset.
b. A dialog box appears prompting you to confirm that you want to restore to factory default settings.
c. Click OK.
5. This option is only available if you set user-defined settings first. (Also, holding the reset button on the
device for 5 seconds sets user-defined defaults) To restore the device's configuration to the user-defined
configuration settings, go to Reset to User-Defined Configuration:
a. Click Restore.
b. A dialog box appears prompting you to confirm that you want to restore to a set of user-defined
settings.
c. Click OK.
6. To set deployment-specific default settings, click Set Current Configuration As User-Defined Default.
a. A dialog box appears prompting you to confirm that you want to restore to a set of user-defined
settings.
b. Click OK.
7. To save a current configuration:
a. Click Save.
b. A dialog box appears asking you if you want to open or save the configuration file. Click Save.
c. Navigate to the location where you want to store the configuration. Click Save.
d. A progress dialog box appears to indicate that the configuration is being saved. Click Close.
Using the Debugging Options
The device has utilities to help troubleshoot and solve technical problems. You can set up your device:
To automatically reboot itself at a particular time of day or use a particular offset in hours from boot.
To record and report Syslog messages that can help you resolve potential issues with your device.
You can also communicate directly with the device's cellular radio. To do this:
1. From Administration, select Debug Options.
2. Click the down arrow to the far right of the Radio Terminal screen to view the terminal window.
3. Enter AT commands to the radio.
See also: Statistics Configuration Fields
Automatically rebooting the device
To specify the amount of time that passes before the device automatically reboots itself:
1. Go Administration > Debug Options > Auto Reboot Timer, select DISABLED, HOUR OF DAY, and TIMER
from the drop-down list under Auto Reboot.
To Next Page
Loading...
Need help?
General
