Chapter 3 – Installing Software
MultiVOIP® Voice/Fax over IP Gateways 33
Configuring the Outbound Phone Book
1. Select Add Entry.
2. To allow unmatched destinations an alternative, check Accept Any Number.
3. In the Destination Pattern field, type the number necessary to get out from the PBX system followed by the
calling code of the destination
4. In the Remove Prefix field, type the PBX access digit. This is the same number as needed to get out of the
PBX system.
5. In the Add Prefix field, type other needed digits.
6. In the IP Address field, type the IP address of the call destination. If desired, in the Description field, add a
description.
7. In the Protocol Type group, select the protocol used.
–SS models use SIP only. -FX models do not support H.323.
a. For H.323, Enter Gateway settings.
b. For SIP: Select Transport Protocol, Proxy and URL if needed.
c. For SPP: Enter Registrar settings if needed.
8. To enter an Alternate IP Address for outbound traffic, click Advanced.
Configuring the Inbound Phone Book
1. Select Add Entry
2. Accept Any Number for inbound traffic does not work when external routing devices are used
3. Enter any access digits followed by the local calling code in the Remove Prefix field
4. Enter any digits needed to access an outside line in the Add Prefix field
5. Select Hunting in the Channel Number field to have the VOIP use the next available channel
6. Add a description if you like
7. Call Forward may be set up (details available in Chapter 5)
8. Select Registration Option
Saving Your Settings and Rebooting
After you change settings on the VOIP unit, you must select the Save & Reboot option. If you do not, all changes
are lost when you reset or shut down the MultiVOIP.
To Next Page
Loading...
