Chapter 4 – Configuring Your MultiVOIP
36 MultiVOIP® Voice/Fax over IP Gateways
Configuration Information Checklist
The following chart helps you organize the configuration information needed. The –SS and –FX models do not
support E&M or DID.
Type of Configuration Info Gathered: Configuration screen where info is entered:
Info
Obtained?
D
Info
Entered?
D
IP info for VOIP unit
• IP address
• Gateway
• DNS IP (if used)
• 802.1p Prioritization (if used)
Ethernet/IP parameters
Interface Type
• E&M
• FXS/FXO*
• DID-DPO
Interface parameters
(*In FXS/FXO systems, channels used for phone, fax, or key
system are FXS; channels used for analog PBX extensions
or analog telco lines are FXO
).
E&M info (only if E&M used)
• Type (1-5)
• 2 or 4 wires
• Dial Tone or Wink
Interface parameters
Country code Regional parameters
Email address for VOIP (optional) SMTP parameters
Reminder: Be sure to Save Setup after entering configuration values.
To Next Page
Loading...
