1
2
3
4
5
Specifying destinations
Checking specified destinations 5-9
Checking specified destinations
You can check or delete the specified destinations at transmission. Either check them
every time you press <Start>, or check them manually as necessary.
NOTE
An icon is displayed in front of the specified destinations in the confirmation screen.
When you set an e-mail address as the destination, it is set as a “To” destination.
To set the destination as a “Cc” or “Bcc” destination, change the setting on the
confirmation screen.
: Fax number or fax number group
: E-mail address set as a “To” destination
: E-mail address set as a “Cc” destination
: E-mail address set as a “Bcc” destination
: Folder
: FTP server
Checking with destination confirmation function
When the confirm destination function is enabled, a screen to confirm or delete the
destinations is displayed every time when you press <Start> after specifying the
destinations.
NOTE
See “Destination confirmation function” (page 4-19) how to setup the function.
1
A screen to confirm or delete the destinations is displayed when you press
<Start>. Confirm the destinations, and press <Start> or [Tx Start].
(Example: Scanner screen)
•To delete a selected destination, select the destination to delete, and press [Delete].
•You can change the destination from “To” to “Cc” or “Bcc”. Select the destination, press [
]
and then [To/Cc/Bcc] to switch from “To” to “Cc”, or “Bcc” destination.
•When you select a destination using the one-touch key, the confirmation screen is displayed
without pressing <Start>.
To Next Page
