Operation Instructions Spitfire 65/90 Extreme
CHAPTER 6 : PRINTER MENU
66 AP-77140 – Rev. 1.1 – 05/04/07
[F4] - Loading ink volume during printing
It is possible to load ink volume to the printer during printing.
There are two possible scenarios:
• SmartChip management system is not empty yet and the printer keeps printing.
Press the F4 key to load ink volume.
• SmartChip management system is empty and the printer stops printing but does NOT cancel the
print.
The following message will appear
Press the F4 key to load ink volume.
Notes
• Please refer to chapter 4.10 to load ink volume properly.
• Please note that the heaters will switch off after 15 minutes. After that point you will have to
reconfigure the heaters manually before resuming the print job. This is the same behaviour as
when a cassette gets empty.
To Next Page
Loading...
