Contents
Getting Started with SCXI x www.ni.com
Table 3-16. SCXI-1121 Amplifier Output Referencing
Jumper Configuration ...........................................................................3-23
Table 3-17. SCXI-1122 Digital Signal Jumper Configurations............................... 3-24
Table 3-18. SCXI-1122 Analog Jumper Configuration........................................... 3-25
Table 3-19. SCXI-1124 Chassis Jumper Configuration...........................................3-27
Table 3-20. SCXI-1124 Device-Type Jumper Configuration.................................. 3-28
Table 3-21. SCXI-1140 Signal Referencing Jumper Configuration........................3-30
Table 3-22. SCXI-1140 Instrumentation Amplifier Jumper Configuration............. 3-31
Table 3-23. SCXI-1140 Gain Switches for Each Channel.......................................3-31
Table 3-24. SCXI-1140 Switch Settings for Gain Selection....................................3-32
Table 3-25. SCXI-1141/1142/1143 Chassis Jumper Configuration ........................ 3-33
Table 3-26. SCXI-1141/1142/1143 Grounding and Shielding
Jumper Configuration ...........................................................................3-34
Table 3-27. NI-DAQ Functions Applicable to the SCXI-1520................................ 3-35
Table 3-28. SCXI-1160 Device-Type Configuration............................................... 3-38
Table 3-29. SCXI-1161 Device-Type Configuration............................................... 3-39
Table 3-30. SCXI-1162 Communication Mode Configuration................................3-40
Table 3-31. SCXI-1162 Parallel Lines Jumper Configuration.................................3-41
Table 3-32. SCXI-1162 Device-Type Jumper Configuration.................................. 3-42
Table 3-33. SCXI-1162HV Jumper Configuration.................................................. 3-43
Table 3-34. SCXI-1163 Device-Type Jumper Configuration.................................. 3-45
Table 3-35. SCXI-1163 Mode Jumper Configuration.............................................. 3-46
Table 3-36. SCXI-1163R Device-Type Jumper Configuration ...............................3-48
Table 3-37. SCXI-1163R Chassis and Mode Jumper Configuration.......................3-49
Table 3-38. SCXI-1200 Analog I/O Settings........................................................... 3-51
Table 3-39. SCXI-1200 Analog Input Configurations.............................................3-52
Table 3-40. SCXI-1200 Jumper Configuration........................................................ 3-54
Table 4-1. SCXI Module and Connector Compatibility .......................................4-1
Table 4-2. TBX Terminal Block Compatibility with SCXI Modules....................4-5
Table 4-3. Excitation Voltage Ranges for Configuration
and Gauge Resistances.......................................................................... 4-15
Table 4-4. SCXI-1122 Maximum Load per Excitation Channel ........................... 4-22
Table 4-5. Sense and Current Output Channel Associations ................................. 4-24
Table 4-6. Pros and Cons of Two-Wire and Four-Wire Connections
with Current-Excited Transducers........................................................ 4-28
Table A-1. Onboard Resources Reserved by SCXI................................................A-5
To Next Page
Loading...
