▪ Effect on a Group: Press Button 2 (GROUP) to select the Group level, then press the de-
sired Group button (A–H) to select the corresponding Group.
▪ Effect on a Sound: Press Button 3 (SOUND) to select the Sound level, press the desired
Group button (A–H), then press the desired pad (or SELECT + the desired pad if the Key-
board mode is active) to select the corresponding Sound.
1. Press Button 5 or 6 to select the effect you want to bypass.
2. Hold SHIFT and press Button 7 above the right display to bypass the selected effect.
The effect unit does not affect the sound anymore. For example, here the Saturator is by-
passed:
3. To reactivate a bypassed effect, press Button 5 or 6 to select the effect.
4. Hold SHIFT and press Button 7 to reactive the effect.
6.3 Modulating Effect Parameters
One of the really cool features of MASCHINE is the ability to modulate parameters from the
Control area in a very easy way — both from the controller and in the software. Modulating a
parameter means recording an offset to its value over time in order for these changes to be
played back again automatically in your song. The modulation data is saved into the current
Pattern. As an example, you could use this to create a filter sweep played in loop with your
Pattern.
Modulation is not limited to effects: In MASCHINE, you can modulate just about any
parameter at the Group or Sound level as soon as it has a continuous range of values —
in other terms, almost any parameter controlled by a knob in the Parameter area!
Applying Effects
Modulating Effect Parameters
MASCHINE STUDIO - Getting Started - 97
To Next Page
Loading...
Need help?
General
