→
Your modulation gets recorded now. On the next loop, the parameter changes will be re-
produced.
There is also another way to record modulation from your controller: the step sequencer.
More on this in ↑7, Creating Beats with the Step Sequencer!
If you want to discard the modulation you just recorded and try again, do the following:
►
Press and hold ERASE, and turn the same Knob 1–8 to delete the modulation of the cor-
responding parameter.
6.3.2 Editing Modulation
We want to quickly mention here that you can also edit any recorded modulation in the soft-
ware. For this, the Control Lane is at your disposal at the bottom of the Pattern Editor:
The Control Lane displays the changes you recorded for each automated parameter.
To edit the modulation:
1. Click the desired parameter in the list of automated parameters (on the left) to select it.
2. Drag the modulation points vertically in the Control Lane.
For more information on editing modulation and automation, please refer to the Manual.
Applying Effects
Modulating Effect Parameters
MASCHINE STUDIO - Getting Started - 99
To Next Page
Loading...
Need help?
General
