Nautel VS1 - Page 138

VS1 Operations and Maintenance Manual Operating the transmitter
Page 2-110 Issue 3.1 2013-10-01
• Notifications: Allows configuration of email notifications to be sent for user-selected alarm
occurrences (see Notifications on page 2-116).
• Exgine Settings: Allows you to set signal parameters and determine IP information for use
with the Exgine option (VSHD only). See Configuring Exgine Settings - VSHD exciter only
on page 2-118.
• SNMP Configuration: Allows configuration of SNMP settings (see SNMP configuration on
page 2-120).
• Capture Critical Parameters: Allows the user to capture critical parameter data for the
transmitter’s current state and paste it to a spreadsheet program (see Critical parameters on
page 2-122).
• External 10MHz: Allows for confirmation of the use of an external 10 MHz reference (see
External 10MHz on page 2-123).
• Spectrum Mask: Allows users to select the appropriate FM mask standard (FCC, ETSI or
None) being used by the analyzer (see Spectrum mask on page 2-125).
• Time Setup: Allows for adjustment of the AUI clock’s time, date, region and time zone (see
Setting the Clock on page 2-125).
• NTP Servers: Allows for configuration and management of NTP servers (see NTP servers
on page 2-128). NTP must be enabled to allow editing; this can only be done using the front
panel UI (see Enabling NTP on page 2-128).
• Nautel Phone Home: Provides a unique diagonostic tool that leverages stored transmitter
information to assist in the analysis of the cause of specific alarms (see Nautel Phone Home
on page 2-130).
•
Call Sign/ID: You can set a name that identifies the transmitter on the AUI (see Setting call
sign/ID on page 2-131).
•
Audio Low Thresholds: Provides adjustable thresholds for the main audio source and SCA
audio source (configurable timeout and trip level). See Audio low thresholds on page 2-132.
Note:
The front panel UI also has a User Settings menu, which contains similar functions to the AUI
(e.g., network setup, external 10 MHz and time setup), and additional settings that are described
in User Settings - Front Panel UI on page 2-133. Unless otherwise noted, the following functions
are only available via a LAN connection to the remote AUI.