VS1 Operations and Maintenance Manual Operating the transmitter
Issue 3.1 2013-10-01 Page 2-163
Enabling and Operating the Orban Audio Processor
This section describes how to configure, enable and operate the optional Orban audio processor after
it is installed in your transmitter. You can interface with audio processor functionality locally, using
the transmitter's front panel UI, or remotely, using the advanced user interface (AUI). The extent of
the features available depends on which interface is used.
• Configuring the Transmitter for the Orban Audio Processor - see page 2-164
• Enabling the Orban Audio Processor for Preset Selection - see page 2-165
• Selecting an Orban Audio Processor Preset - see page 2-167
• Managing an Orban Audio Processor Preset - see page 2-169
Note:
Using the Orban Inside option requires the installation of an Orban audio processor card in your
transmitter. If you had a pre-existing transmitter when you received your Orban Inside kit, verify
that the Orban card has been installed in the transmitter according to the NVLT - Orban Inside
Quick Guide (QG12001), provided with the Orban Inside kit. Refer to the Pre-installation and
Installation Manuals for information on purchasing and installing this option.
Note:
This section contains frequent reference to Orban's Optimod-FM 5500 Digital Audio Processor
Operating Manual (see the link below). The equipment covered in the 5500 manual uses the same
Orban audio processor as in your transmitter. The 5500 manual provides detailed information on
the audio processor's functionality. If a discrepancy exists between the operational instructions in the
Orban manual and this document, the latter shall prevail as this document is specific to operation
with an VS1 transmitter. View the Orban Optimod-FM 5500 Digital Audio Processor
Operating Manual online at:
ftp://ftp.orban.com/5500/Documentation/
(the version number referenced in this link is controlled by a third party and is subject to change
without notice)
To Next Page
Loading...
