NCR 7454 - Completing the os Installation (Winxpe); Completing the os Installation (Winnt)

4-6 Chapter 4: Operating System Recovery
7. RuntheMicroTouchscreencalibrationfromtheDesktopicon.
Completing the OS Installation (WinXPe)
Thesystemautomaticallyrebootswhentheimagerecoveryiscomplete
andstartsthesoftwareinstallation.Thisinstallationalsoinstallsmost
oftheadditionalsoftwareanddriversthatareincludedinthedisk
image.Completetheinstallationasfollows.
1. ClicktheAdminbuttontologinasAdministrator.
2. ReadtheEULA
(End‐UserLicenseAgreement)informationinthe
DOSwindow,thentypeEXITandpressEntertoclosetheDOS
window.
3. StarttheNetworkSetupWizard.
4. Selectoptionstoidentifythenetworkinformationfortheterminal
environment.
5. EntertheComputerDescription.
6. EntertheComputerName.
7.
EntertheWorkgroupName.
8. Whenprompted,pressFinishtoreboottheterminal.
9. Loginwhenprompted.
10. OpentheControlPanelorusetheTouchWareIcon on thedesktop
andruntheMicroTouchscreencalibration.
Completing the OS Installation (WinNT)
Thesystemautomaticallyrebootswhentheimagerecoveryiscomplete
andstartsthesoftwareinstallation.Thisinstallationalsoinstallsmost
oftheadditionalsoftwareanddriversthatareincludedinthedisk
image.Completetheinstallationasfollows.
1. Aftertheterminalreboots,pressNextattheWindowsSetupscreen.