NCR 7454 - Completing the os Installation (Win98)

Chapter 4: Operating System Recovery 4-7
2. AccepttheMicrosoftlic ense agreement.
3. EntertheUserNameandOrganization.
4. EntertheComputerNamefortheclient.
5. EntertheAdministrator’sAccountPassword(optional).
6. Whenprompted,pressFinishtoreboottheclient.
7. Loginwhenprompted.
8. OpentheControlPanelandrunthe
MicroTouchscreencalibration.
Completing the OS Installation (Win98)
Thesystemautomaticallyrebootswhentheimagerecoveryiscomplete
andstartsthesoftwareinstallation.Thisinstallationalsoinstallsmost
oftheadditionalsoftwareanddriversthatareincludedinthedisk
image.Completetheinstallationasfollows.
1. Whentheterminalbootsitenters theWindowssetuproutine.
Note: When
installingWin98onterminalswithearlyProcessor
Boards(7454‐22xx)therearefewdifferencesintheprocedureas
follows:
a) TheterminalstartstheAddNewHardwareWizard. 
b) Foreachdevicefound,permitWindowstosearchfornew
drivers(takedefaults).
c) Aftereachdriverisinstalledyouare
askedtoreboot.Answer
No.
2. AttheUserInformationscreen,entertheUserinformation.This
canbedoneusingakeyboardoryoucanusethetouchscreen
keyboard.Afterenteringtheinformation,press
EnterortouchOK.
3. GointotheControlPanelandsettheterminalDateandTime.
4. IntheControlPanel,runtheMicroTouchscreencalibration.