NCR 7454 - Chapter 3: Setup; Introduction; BIOS Versions; Entering Setup Without a Keyboard

Chapter 3: Setup
Introduction
ThischapterdescribeshowtoconfiguretheBIOSCMOSoptions.
FollowingthisIntroduction,therearesectionsspecifictoPentium
terminalsandsectionsspecifictoPentiumIII/Celeronterminals.
Note: Anexternalalphanumerickeyboardisnotrequir edtorunthe
BIOSCMOSSetupUtility,buta keyboardmakesthesetupeasier.
BIOS Versions
TheSetupMenusinthischapterreferenceNCR7401/7454BIOS
Version1.5.0.4(Pentium)andNCR7401/7452/7453/7454/7455BIOS
Version2.1.2.x(PentiumIII).
Entering Setup Without a Keyboard
1. Applypowe rtotheterminal.
2. Calibratethetouchscreen.
a) WhenthescreenpromptthatsaysTouchthescreentwotimesto
enterSetupappears,touchthescreenthreetimes.Thiscauses
thesystemtobypasstheBIOSSetupandgodirectlytothe
TouchScreenCalibrationSetup.
Note:
SetupcanalsobeenteredfromtheBootMenuthatis
displayedwhenyoupress
ESCduringPOST.