NCR 7454 - Completing the os Installation (Win98); Completing the os Installation (Win95)

2-28 Chapter 2: Hardware Installation
Completing the OS Installation (Win98)
Thesystemautomaticallyrebootswhentheimagerecoveryiscomplete
andstartsthesoftwareinstallation.Thisinstallationalsoinstallsmost
oftheadditionalsoftwareanddriversthatareincludedinthedisk
image.Completetheinstallationasfollows.
1. Whentheterminalbootsitenters theWindowssetuproutine.
Note: When
installingWin98onterminalswithearlyProcessor
Boards(7454‐22xx)therearefewdifferencesintheprocedureas
follows:
a) TheterminalstartstheAddNewHardwareWizard. 
b) Foreachdevicefound,permitWindowstosearchfornew
drivers(takedefaults).
c) Aftereachdriverisinstalledyouare
askedtoreboot.Answer
No.
2. Atthe
User Informationscreen,entertheUserinformation.Thiscan
bedoneusingakeyboardoryoucanusethetouchscreen
keyboard.Afterenteringtheinformation,press
EnterortouchOK.
3. GointotheControlPanelandsettheterminalDateandTime.
4. IntheControlPanel,runtheMicroTouchscreencalibration.
Completing the OS Installation (Win95)
Thesystemautomaticallyrebootswhentheimagerecoveryiscomplete
andstartsthesoftwareinstallation.Thisinstallationalsoinstallsmost
oftheadditionalsoftwareanddriversthatareincludedinthedisk
image.Completetheinstallationasfollows.
1. Aftertheterminalreboots,pressNextattheWindowsSetupscreen.
2.
AttheUser Informationscreen,entertheUserinformation.Thiscan
bedoneusingakeyboardoryoucanusethetouchscreen
keyboard.Afterenteringtheinformation,press
Enter ortouchOK.