NCR 7454 - Installation Restrictions

2-2 Chapter 2: Hardware Installation
Installation Restrictions
• Beforeinstallingtheterminal,readandfollowtheguidelinesinthe
NCR7454RetailTerminalSitePreparationGuideandtheNCR
WorkstationandPeripheral ACWiringGuide.
• Installtheterminalnearanelectricaloutletthatiseasilyaccessible.
Usethepowercordasapower‐disconnectdevice.
•
Donotpermitanyobjecttorestonthepowercord.Donotlocate
theterminalwherethepowercordcanbewalkedon.
• Useagroundingstraportouchagroundedmetalobjectto
dischargeanystaticelectricityfromyourbodybeforeservicingthe
terminal.
• Ifthepower
cordisreplaced,itmustbereplacedwiththesame
typeofcordwiththeprotectiveshroud.
• Donotroutethepowercordthroughopeningswithsharpedges.
Caution: This unitcontainshazardousvoltagesandshouldonlybe
servicedbyqualifiedservicepersonnel.
Caution: DONOTconnectordisconnectthe
transactionprinterwhile
theterminalisconnectedtoACpower.Thiscanresultinsystemor
printerdamage.
Warning: The7454mustbemountedsecurelytopreventahazard.It
mustbeinstalledinaccordancewithlocalbuildingcodes.Thepostor
wallonwhichtheunitismountedshouldbe
abletowithstandfour
timestheweightoftheunit,whichisapproximately20lbs.(9kg).