NCR 7454 - Page 141

Chapter 5: BIOS Updating Procedures 5-3
5. Boottheterminal.
6. Press
F2atthescreenprompttoentertheSetupUtility.
7. Inthe
Advancedmenu,selectI/O Device Configuration.
8. Verifythatthe
LPT 1 ModeissettoECP.
9. Gobacktothe
Advanced menu,selectMultiple ROM Menu.
10. Setthe
Parallel CD-ROM BoottoEnabled.
11. ExitSetupandSaveChanges.
Astheterminalreboots,youshouldseeamessageduringboot
indicatingthattheCD‐ROMhasbeenrecognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
12. FollowthescreenpromptsontheclienttoupdatetheBIOS.You
canselecttwomethodstoruntheupdateprogram.
• AutomaticBIOSUpdate–updateprocessrunsunattended
Note: Youseea promptforterminalmodelandserialnumber
information.Iftheprogramdetectsinvalidinformationinthe
currentBIOS,orifyouarereplacingtheProcessorBoard,there
isnotmodel/serialnumberinformationintheBIOS.
Important:Model/SerialNumberismandatoryforFitClient
operation.
• InteractiveBIOSUpdate–permitsyoutoinput/replacethe
model/serialnumberinformationthatisstoredintheBIOS.
Note: Model/Serialnumberdatathat
iscurrentlystoredinthe
BIOSisdisplayedduringpowerup.