NCR 7454 - Page 68

2-18 Chapter 2: Hardware Installation
Installation Procedure
1. Routethecable(displayconnectorend)upthroughthePower
SupplyCover,DisplayPost,andTopBracket.Thisisatightfitand
theconnectorhastobeangledinordertomakeitthoughthe
openings.Usecaretonotdamagethewires.
19949a
Top Bracket
Display Post
Power Supply Cover
4 x 20 Integrated
High-Post Cable

2. InsertthepostintotheholeonthetopofthePowerSupplyCover.
Notetheorientationabove.Theslotonthebottomendofthepost
shouldfacetheinsideofthecover.
3. InstalltheTopBracketontothepost.